RTX 4060 LP 170mm cooler
The Gigabyte RTX 4060 low profile is a great card, but it's too long for many low profile cases. You can solve that issue with this custom heatsink, machined from pure copper. Combine it with the included 3D printed shroud, which mounts the 3 original fans, and you have a true ITX-length card.
Note: due to time and resource constraints, this product is on a hold for now.
RTX 4060 LP: a great card, but it's too long
The Gigabyte RTX 4060 low profile is an innovative little card and is the best consumer-grade low profile GPU. It comes with a large disadvantage, though: It is longer than 170 mm. Many low profile computer cases have a hard GPU clearance limit around 170 mm, so cannot fit this card.
In comes this product: a custom heatsink to take away that disadvantage. This heatsink will bring the card's length down to the general considered 'ITX length' of 170mm, making it compatible with all low profile computer cases.
What's required?
This set includes the heatsink, 3D printed shroud and mounting screws. The original thermal pads and fans are reused as they are good quality.
You will need to provide some thermal paste for the chip. If you want to stay below 170 mm length, a reverse 8-pin adapter is required. The bend should be towards the locking clip. They are widely available on shops like Amazon or Aliexpress.
Due to the heatsink being smaller than the original, it will be louder after replacing the cooler. It is advised to undervolt your card to make it much quieter under load without losing any performance.
Important information
Replacing the heatsink of your graphics card will void the warranty, doing so is your own responsibility. Use this heatsink at your own risk, I cannot be held responsible for damage to your card during installation or usage of this heatsink.